Important Notes; Safety Notes; Power Cable And Mains Adapter; Transporting The Device - Fujitsu PalmSecure ID Match Operating Manual

Table of Contents

Advertisement

Important notes

Important notes

In this chapter you will find information regarding safety which it is essential to take note of when
working with your device.

Safety notes

Pay attention to the information provided in the "Safety/Regulations" manual and in the
following safety notes.
During installation and while operating the device, please observe the instructions on
environmental conditions in the "Technical data" chapter and the instructions in the "Initial
startup" chapter.
Repairs to the device must only be carried out by qualified technicians.
Incorrect repairs could put the user at great risk (electric shock, hazardous energy emissions,
risk of fire) or cause serious damage to the equipment.
Operate the device only with the casing closed.
Keep a minimum distance of 7 cm away from the RFID antenna in compliance with the
radiation level.
Do not use the device close to the body during continuous operation.

Power cable and mains adapter

The supplied power cable conforms to the requirements of the country in which you purchased
your device. Make sure that the power cable is approved for use in the country in which you
intend to use it.
The mains adapter's power cable should only be connected to a mains socket if the device is
connected.
Do not use the mains adapter for other devices.
Use only the mains adapter which is intended for use with the device, see chapter "Technical
data".
Make sure that the rated current of the mains adapter is not higher than that of the power
supply system to which you connect the mains adapter.
ON/OFF switches do not disconnect the device from the mains voltage. To completely
disconnect the mains voltage, remove the mains supply plug from the mains supply socket.

Transporting the device

.
Transport all parts separately in their original packaging or in packaging which protects them
from knocks and jolts.
Do not unpack them until at the place where they are to be set up.
If the device is brought from a cold environment into the room where it will be used,
condensation may occur. Before operating the device, wait until it is absolutely dry and has
reached approximately the same temperature as the room in which it will be used.
4

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents