Table of Contents
Advertisement
INSTALLATION
Installation Guidance
(1) Open the package; take out R6, R12 and the accessories.
(2) Install four U-rings into one flying frame.
(3) Demount the ball-catch bolt from the pulling plate of R6,
place R12 pulling plate lockpin into the slot of R6 pulling
plate with holes against each other; put the ball-catch
bolt back.
(4) Insert connecting rod into R6 rear and angle-adjustment
slot of R12 on the bottom, adjust angle according to
practical needs.
(5) Install one or multiple sets of R6 by sequence onto the
bottom of the previous R6.
M8 locknut
R12 pulling plate
R6 pulling plate
components
Warning: Make sure the mounting accessories safety
factor not less than 5:1 or meet the local standard
during installation.
COMPACT LINE ARRAY SOUND REINFORCEMENT SYSTEM
Flying Frame
R6 rear connecting
rod components
R Series Medium Line Array System
Wheel bracket 1-AZPJ-85)
Method of angle adjustment:
When the angle of hole against the connecting rod
hole is 0 , insert the bolt, the vertical binding angle
of two cabinets is 0°.
R12
4 inch wheel
4-YXPJ-112 with baking
4-YXPJ-113 without baking
R6 rear connecting
rod on the top
R6 rear connecting
rod at the bottom
5
Advertisement
Table of Contents
