Scope; Specifications - Laird WB50NBT User Manual

Wireless bridge module
Hide thumbs Also See for WB50NBT:
Table of Contents

Advertisement

WB50NBT
Hardware Integration Guide
S
COPE
This document describes key hardware aspects of the Laird WB50NBT
wireless bridge module. This document is intended to assist device
manufacturers and related parties with the integration of this module
into their host devices. Data in this document are drawn from a number
of sources including data sheets for the Laird SSD50NBT, QUALCOMM
Atheros AR6004, CSR CSR8811, and Atmel ATSAMA5D31A.
Because the LAIRD WB50NBT is currently in development stage, this
document is preliminary and the information in this document is subject
to change. Please contact Laird to obtain the most recent version of this
document – http://ews-support.lairdtech.com.
S
PECIFICATIONS
Feature
Physical Interface
Ethernet Interface
(3.3 V signal level)
Asynchronous Serial
Port Interfaces
(3.3 V signal level)
SPI Interface
(3.3 V signal level)
USB Interfaces
Two Wire Interface
(3.3V signal level)
Debug Interface
Digital GPIO
(3.3 V signal level)
PCM interface
Antenna Interface
Wi-Fi Interface
Bluetooth Interface
Processor Chip Set
Operating System
Embedded Wireless Solutions Support Center:
http://ews-support.lairdtech.com
www.lairdtech.com/wi-fi
Description
Pitch: 0.5 mm
Kyocera (AVX) – P/N: 245046120600829+
Mating part:
Kyocera (AVX) – P/N:145046120640829+
Stacking height = 4.0 mm
Note: See
mounting
for mating connector options.
10/100 Mbps RMII (Reduced Media Independent Interface)
Four-wire UART with hardware handshaking (up to 921,600 baud)
Full mode UART with synchronous clock to support USART interface
Five Wire, Master and Slave modes supported with two chip select
One USB device port with high speed/full speed/low speed data rates
Two USB host ports with high speed/full speed/low speed data rates
Two-wire I2C (Inter-IC)
Two-wire UART (console) for debug purpose
Six digital General Purpose I/O (GPIO)
13-bit or 16-bit linear, 8- it μ-law or A-law companded sample formats
2 Hirose U.FL connectors for Wi-Fi (Main/AUX) and BT (AUX only) separately,
50 ohm
Qualcomm Atheros AR6004 2x2 802.11 a/b/g/n on 20/40 MHz bandwidth
CSR CSR8510 Bluetooth 4.0 dual-mode (EDR+BLE)
Atmel 536 MHz ARM 9, P/N ATSAMA5D31A
Embedded Linux, 4.1 kernel
© Copyright 2016 Laird. All Rights Reserved
4
Americas: +1-800-492-2320
Europe: +44-1628-858-940
Hong Kong: +852 2923 0600

Advertisement

Table of Contents
loading

Table of Contents