Water Solenoid - Hamilton Beach SmartServe MIC2000 Service Manual

SmartServe™ Drink Mixers Service Manual

Water Solenoid

The MIC2000 has two water solenoids and the BIC2000 only has one water solenoid. The
BIC2000 is the model shown. Removal procedure for both is similar. See the Water and Valve
Diagrams for hose and valve positions.
NOTE: Make note of water flow indicators on solenoid (small arrow on underside of intake
side) and water flow directions on solenoid support (IN, OUT, and REAR stamped into metal to
indicate flow direction and solenoid support orientation) to install new solenoid and water lines
in correctly.
To avoid risk of serious injury or death, disconnect power to the machine before
Do not use power tools to remove hardware. Damage to the hardware or the machine
To remove the water solenoid:
1. Shut off water supply, disconnect water line from machine, and purge the system to
remove water from the lines.
2. Ensure the control panel power switch (1) is in the OFF position and unplug the
machine.
Removal and Replacement
cleaning, servicing, or removing parts.
may occur. Do not lose hardware.
1
WARNING
CAUTION
Page 70 of 92
520008300 08/14