Care And Maintenance - Kobalt KSB 5080-06 Manual

CARE AND MAINTENANCE

IMPORTANT: Always remove the
battery from the tool before performing any
maintenance on it.
1. REPLACING THE SCRAPER
NOTE: The scraper is located at the bottom of the
impeller housing. Ensure that the battery is not
installed in the tool.
• Turn the machine to its side.
• Remove the 5 bolts below the deck that attach
the scraper to the machine.
• Remove the worn scraper (N) from the
machine.
• Install the new scraper.
• Install and tighten the bolts that you removed.
2. REPLACING THE DRIVE BELT
• Remove the screws on the drive belt cover (O).
• Turn the auger pulley (P) counterclockwise
while you remove the remaining belt (Q).
• Turn the new belt onto the pulleys.
• Install and tighten the screws that you
removed.
1
Bolt
2
Screw
O
P
16
N
Q