Control Panel - Firman P03615 Owner's Manual

Control Panel

2
1
NOTE: Total power drawn from all receptacles must not exceed the name plate rating.
Engine Start Switch – Used to start engine
1
from the starter motor(Electric start model
only). To start engine, press and hold the
switch in the "START"(ll) position, the
engine will crank and attempt to start. When
the engine starts, release the switch to the
"RUN"(l) position.
2
4-1 Data-Minder(Multi-Meter) – Push the
SELECT button to show the Voltage, Hertz and
running hours. If the low oil indicator is lit,
check the oil level.
A - Digital display
B - AC voltage indicator
C - Frequency indicator
Battery Power Restore Switch – Restore the
3
battery power to the control module. You must
press this switch and hold for 3 seconds before
start the generator, including recoil,
electric and remote start.
DC Circuit Breaker- Protect the DC receptacle.
4
5 12V DC Outlet Receptacle- Maximum full load
8.3 Amp current may be drawn from this 12 Volt
receptacle.
120/240V, 30A Twist-Lock – (NEMA L14-
6
30R) May be used to supply power for the
operation of 120/240 Volt, 30Amp.
English
3
4 5
D - Hour indicator
E - Low oil indicator
F - Select button
6 7
10
240V 120V
16
15 12
14
12
7
8 120V, 20A Duplex ( NEMA 5-20R)
Maximum full load 20 Amp current may be
drawn from this 120 Volt receptacle.
120V, 30A RV (NEMA TT-30R)
9
Maximum full load 30 Amp current may be
drawn from this 120 Volt receptacle.
Two 3.1Amp-5.0 Volt DC USB Ports
10
Outlet Cover - Protect the receptacles from
11
dust and debris.
LED Light
12
Ground Terminal – Consult an electrician
13
for local grounding regulations.
Voltage Selector Switch – To select
14
between 120 Volt or 240 Volt.
15
Page 11
9
8
7
13
12
Customer Service: 1-844-FIRMAN1
17
11