Hour Service - Ransomes CG161 Operator Instructions Manual

PRE-DELIVERY SERVICE
CHECK AND ADJUST AS REQUIRED
INOPERATIVE SERVICE CHECKS
1. Tire pressure ...............................
2. Air cleaner element and hose
connections .................................
3. Radiator coolant level ..................
4. Fan belt tension ...........................
5. Battery cleanliness, vent openings,
electrolyte level, and charge ........
6. Engine oil level ............................
7. Power steering reservoir oil level .
8. Transmission and rear axle ..........
9. Front axle and front differential oil
level (4WD) ..................................
10. Hydraulic Lift control adjustment ..
11. upper link, and hitch ....................
12. Brake adjustment and pedal
equalisation .................................
13. Rear wheel disc and hub bolts for
tightness ......................................
14. Front wheel hub bolts fo
tightness (4WD) ..........................
15. Front wheel toe-in ........................
16. Fuel level .....................................
17. Sheet metal and paint condition ...
18. check lift rod for proper operation
19. Drain diesel fuel filter ...................
INOPERATIVE SERVICE CHECKS
1. Tire pressure ................................
2. check air cleaner hose connection
3. Replace diesel fuel filter(s) ............
4. Tighten in-line pump delivery valve
holders .........................................
5. Radiator coolant level ...................
6. Fan belt tension ............................
7. Battery cleanliness and vent
openings, electrolyte level and
charge ..........................................
8. All electrical cables, terminals and
wires .............................................
9. Drain and refill engine oil ..............
10. Replace engine oil filter ................
11. Power steering reservoir oil level ..
12. Transmission and rear axle oil level
13. Front differential and front axle .....
14. Injection pump timing ....................
15. cylinder head bolt torque ..............
16. Replace hydraulic system oil filter .
17. Replace H.S.T. cartridge oil filter ..
18. Bolt torque check of ROPS and seat
belt ..............................................
48
PRE-DELIVERY SERVICE
CHECK AND ADJUST AS REQUIRED
SAFETY ITEMS CHECKS
1. ROPS installed ...............................
2. Seat belts installed .........................
3. Bolt torque check of ROPS
and seat belt ...................................
4. PTO master shield installed ............
5. Safety decals installed ....................
6. Neutral start switches operation ......
7. Parking brake & latch operation ......
8. Flashing lights/tail lights operation ..
9. Operator's Manual ..........................
TRACTOR MODEL NO. ............................
OWNER'S SIGNATURE

50 - HOUR SERVICE

CHECK AND ADJUST AS REQUIRED
OPERATIVE SERVICE CHECKS
1. Lights and instruments for proper
operation, and fuel shut down with key
switch OFF .....................................
2. Fluid and oil leaks ...........................
3. Maximum no-load speed and idle
speed adjustments .........................
4. Starting and starter safety switches
5. Valve lash .......................................
6. Hydraulic system:
• Selector lever for position control
operation ........................................
• Flow control operation ....................
Note: Flow control only on
H.P.L lowering rate speed can be adjusted
TRACTOR MODEL NO. ............................
OWNER'S SIGNATURE
OPERATIVE SERVICE CHECKS
All operating checks are to be performed
with the tractor at normal operating
temperature
1. Lights and instruments for proper
operation, and fuel shut down
with key switch OFF .........................
2. Fluid and oil leaks ............................
3. Maximum no-load speed and
idle speed adjustments ....................
4. P.T.O. engagement and
disengagement ................................
• clutch pedal and P.T.O. lever ...........
5. Hydraulic System:
• Selector lever for position control .....
• Flow control operation .....................
6. 4-wheel drive lever operation ...........
7. Low speed (creeper) lever ...............
8. Operation of H.S.T ...........................
TRACTOR SERIAL NO. ..........................
INSPECTION PERFORMED
WARRANTY EXPLAINED
DATE DEALER'S Signature
PERFORMANCE SERVICE CHECKS
1. Engine operation including throttle and
governor operation ..........................
2. Transmission including clutch ..........
3. Steering control ...............................
4. Differential lock engagement and
disengagement ................................
5. Brake action ....................................
6. All optional equipment and accessories
7. Hydrostatic Transmission .................
TRACTOR SERIAL NO. ..........................
INSPECTION PERFORMED
DATE DEALER'S Signature
DATE
DATE