Sherwood RD-7503 Operating Instructions Manual page 58

RD-7503(A) 2008.11.4 1:45 PM 페이지 58
Memorizing the adjusted channel levels
• You can memorize the adjusted channel levels into preset memory("REFERENCE 1", "REFERENCE 2") and recall the
memorized whenever you want.
1.
After performing the steps 1~3 in "Adjusting the current channel level" procedure on page 57, press the
CURSOR UP(▲)/DOWN(▼) buttons to select a channel (, not the MODE (memory mode) and the LFE
LEVEL SETUP), then press the ENTER button.
2.
Press the CURSOR LEFT(◀)/RIGHT(▶) buttons to select the desired preset memory, then press the
ENTER button.
Recalling the memorized channel levels
1.
Press the CURSOR UP(▲)/DOWN(▼) buttons to select the MODE(memory mode).
2.
Press the CURSOR LEFT(◀)/RIGHT(▶) buttons to select the desired one of REFERENCE 1 and
REFERENCE 2.
• The "REFERENCE 1" indication flickers.
• Each time the CURSOR LEFT(◀) or RIGHT(▶) button is
pressed, "REFERENCE 1" or "REFERENCE 2" is
selected.
• The adjusted channel levels have now been memorized
into the selected memory.
• "CALIBRATE" may be displayed instead of
"REFERENCE 1" or "REFERENCE 2".
• Then the channel levels memorized into the selected
preset memory are recalled.
58