Lamp Led Indicators - Samsung SHP-700 Owner's Instructions Manual

Lamp LED Indicators

● The warning LED indicator notifies you when a problem occurs inside the projector.
● The TEMP LED indicator turns on when the projector generates too much heat.
● The LAMP LED indicator turns on when you should replace the lamp.
35
Common Troubles and Actions
LED Indicator Cause
TEMP LED The internal
Indicator temperature is
high.
LAMP LED The lamp does
Indicator not turn on.
The lamp should The lamp has been
be replaced.
● If a warning LED indicator turns on, please use the projector only after it has
completely cooled down (please wait for more than 5 minutes).
● When the power is turned off and on, the lamp LED indicators may blink in
order to prevent the loss of power consumption.
In this case, disconnect the power cord from the power outlet and reconnect
it.
● Please contact a service center or product distributor when the lamp is bro-
ken.
● Do not remove the lamp immediately after using your projector. Please dis-
connect the power cord and wait 1 hour before replacing the lamp, as it will
have heated up during use.
Lamp LED Indicators
Symptom Action
Air is not flowing Move your projector to a
into your projector. well-ventilated place.
Air filter is full. Clean the filter.
Cooling fan is Please contact a service
out of order. center or product distributor.
Internal circuit has
failed.
The lamp has Please replace the lamp.
burned out. Please contact a service
The lamp circuit is center or product distributor.
out of order.
used for more than
1,900 hours.