Led Indications; Using The Screen Adjustment Menu (Osd: On Screen Display) - Samsung SP-P410ME Owner's Instructions Manual

3-4

LED Indications

LED Indications
:Light is On :Light is Blinking
STAND BY TEMP
Clearing Indicator Problems
CLASSIFICA
TION
Action 1 When the cooling fan system is
not in normal operating condi-
tion.
Action 2 When temperature inside of the
projector becomes too high.
Action 3 When the sensor system inside
the projector is not operating
normally.
This Projector uses a cooling fan system to keep the unit from overheating. Operation of the cooling fan may cause noise,
which does not affect the product performance and is part of normal operation.
3-5

Using the Screen Adjustment Menu (OSD: On Screen Display)

The Screen Adjustment Menu (OSD: On Screen Display) Structure
3-4
:Light is Off
This state occurs when power is supplied to the projector normally after the POWER button
on the projector or the remote control has been pressed.
• This state appears when the projector is preparing an operation after the POWER button
on the projector or the remote control has been pressed.
• The POWER button is pressed to turn off the projector, and the cooling system is in
operation to cool off the inside of the projector.
• This is the state where the product is turned off automatically since there was no signal
input while a PC cable was connected.
The projector is in normal operating condition.
Refer to Action 1 below if the cooling fan inside the projector is not in normal operation con-
dition.
Power is turned off automatically when temperature inside of the projector goes beyond
the control limit. Refer to Action 2.
This state occurs when the auto color compensation function has an error. Refer to Action
3.
STATE
If the symptom remains even after disconnecting and then reconnecting
the power cord and turning the projector on again,
vice
Adjust the installation state of your projector by referring to the Installation
Precautions section listed above. Cool down your projector sufficiently and
then operate it again. If the same problem occurs continually,
Samsung
Cool your projector down sufficiently and then operate it again. If the same
problem occurs again,
INFORMATION
MEASURES
center.
service center.
contact a Samsung
contact a Samsung
contact a
service center.
ser-
Using