Sherwood Newcastle R-925 Operating Instructions Manual page 22

Entering video labels
It can be operated only on video input sources such
as DVD, LDP, VCR 1 and AUX/TV.
Select the desired video input source to
1
enter its label.
INPUT SELECTOR/
INDEX
Press the VIDEO LABELS
2
button for more than 2
seconds.
Select the first character of the video label
3
while the digit is flickering.
Each time the INPUT SELECTOR/INDEX knob is
rotated, the characters which can be selected are total
45 as follows ;
26 Capital Letters : A B C D E F G H I J K L M N O P
Q R S T U V W X Y Z
10 Arabic Numerals : 1 2 3 4 5 6 7 8 9 0
9 Special Marks : '< >
Memorize it within
4
6 seconds.
If the MEMORY/ENTER button is pressed for more
than 2 seconds on the character, a dot(·) will appear
by the character.
If the MEMORY/ENTER button is pressed without
selecting the desired character, the digit will be blank.
If 6 seconds elapses, repeat again from the step 2.
or
DVD
VCR1 AUX/TV
LDP
VID.LABELS
INPUT SELECTOR/
INDEX
+ , - / \
MEMO / ENTER
22
Repeat the steps 3 and 4 to memorize the
5
rest of up to 8 characters.
Rectifying or clearing a video label
Select the desired video input source to be
1
rectified or cleared.
INPUT SELECTOR/
INDEX
Repeat the steps 2~5 in "Entering video
2
labels" procedure.
To clear a video label, make a blank on each digit,
then the video label is cleared and its video input
source will be displayed.
Checking the video components
connected
Use this function to check the video components
connected to DVD, LDP, VCR 1 and AUX/TV jacks
each.
During play on the video components, press the
VIDEO LABELS and the VCR 1 RECORD buttons
simultaneously.
VID.LABELS
The respective input source or its label scrolls on the
display and you can check its video and audio
contents in turn as follows;
→ →
DVD LD PLAYER VCR 1
AUX/TV REAR
During recording, do not check the video
components connected.
or
DVD
AUX/TV
VCR1
LDP
VCR 1 REC
→ →
AUX/TV FRONT