Sherwood Newcastle R-925 Operating Instructions Manual page 15

In Dolby DIGITAL(AC -3), Dolby Pro
Logic or Dolby 3 Stereo mode
Press the TEST TONE button to adjust the
7
volume level of each speaker.
Test tone will be heard form each speaker for 2
seconds each as follows;
FRONT L CENTER FRONT R REAR R REAR L SUB
The test tone will be heard from the subwoofer only
when subwoofer is set to "YES" in the Dolby
DIGITAL(AC-3) mode.
Test tone is not heard from rear speakers in Dolby 3
Stereo mode.
Test tone is not heard from center speaker when the
center speaker setting is adjusted to the NONE
mode.
Adjust the volume levels of the speakers
8
until they all sound equally loud.
CENTER LEVEL
- CENTER LEVEL +
or
REAR LEVEL
- REAR LEVEL +
SURBWOOFER LEVEL
SUBWOOFER
The rear L and R volume levels are adjusted
respectively during the test tone function and all
together while enjoying surround sounds.
Cancel the test tone function.
9
T.TONE
T.TONE
15
Check the delay time to be adjusted.
10
D.TIME
• The delay time will be displayed for 5 seconds.
• In Dolby DIGITAL(AC-3) mode, the corresponding
delay time will be flickering.
• The center delay time can be adjustable only in Dolby
DIGITAL(AC-3) mode.
• The rear delay time can be adjustable only in Dolby
DIGITAL(AC-3) and Dolby Pro Logic modes.
Adjust the delay time.
11
Each time this button is pressed, the delay time
changes in regular intervals.
If the delay time disappears, start from the step 10
again.
Memorize the delay time.
12
In Dolby Pro Logic mode, the
rear delay time can be
memorized without pressing
the DELAY TIME button.
In Dolby DIGITAL(AC-3) mode, repeat
13
the above steps 11 and 12 to adjust the rear
delay time.
In THEATER, HALL, STADIUM or
CHURCH Mode
Adjust the volume level of the rear speakers
7
relative to that of the front speakers.
– REAR LEVEL +
or
AD JUST
D.TIME
REAR LEVEL