Other Possibilities - Sherwood Newcastle R-525 Operating Instructions Manual

SLEEP
The sleep mode allows the system to continue to operate for
a specified period of time before automatically shutting off.
Press the SLEEP button.
– The display shows the indication SLEEP 10.
– This means that the system will be switched to standby
after 10 minutes.
Select the required sleep time by pressing SLEEP : 10,
20, 30, 60 or 90 minutes.
Notes:
– During an active sleep timer period, you can reset the
SLEEP time again by pressing the SLEEP button.
– A sleep timer period will be cancelled when you switch
your system to standby (using the POWER button on your
remote control).
ENTERING VIDEO LABELS
– It can be operated only on video functions such as VCR1,
VCR2, and LDP.
Select the desired video input to enter its label.
Press the VIDEO LABELS button for more than 2
seconds.
Rotate the INPUT SELECTOR/INDEX to select the first
character of the video label.
– Characters which can be selected are total 46 as follows;
26 Capital Letters : A B C D E F G H I J K L M N O P Q R
S T U V W X Y Z
10 Arabic Numerals : 1 2 3 4 5 6 7 8 9 0
10 Special Marks : ' < >
Press the MEMORY/ENTER button to store it.
– If you press the button for more than 2 seconds on the
character, a dot will appear by the character.
Repeat the same steps as described above to store the
rest of up to 8 characters.
Note : This procedure must be done in a timely fashion.
CINEMA BASS
You can turn on CINEMA BASS to enjoy impressive bass
sound by pressing it.
Press it again to cancel.
+ , – / \ .

OTHER POSSIBILITIES

SUBWOOFER LEVEL CONTROL
Use the SUBWOOFER LEVEL buttons on the remote
control to adjust the subwoofer level.
– The level will be indicated on the display : MIN, -21,. ... , -
2, -1, 0, 1, 2, . ... , +8, MAX.
AUDIO RECORDING
Recording with TAPE 1
Select the desired input as recording source.
Start recording on the TAPE 1.
Start play on the desired input.
Recording with TAPE 2 MONITOR
Select the desired input as recording source.
Set the TAPE MONITOR button to on.
Start recording on the TAPE 2 MONITOR.
Start play on the desired input.
– When the TAPE 1 is selected as recording source,
dubbing will start from TAPE 1 to TAPE 2 MONITOR.
– It is not impossible to dub from TAPE 2 MONITOR to
TAPE 1.
– For tape 2 monitor function, refer to amplifier chapter
titled "TAPE 2 MONITOR function".
RECORDING WITH VCR 1
Dubbing from LDP(VCR 2) to VCR 1
Select LDP(VCR 2) as the input being enjoyed.
Select LDP(VCR 2) as recording source with the VCR 1
RECORD button.
– Each time this button is pressed, the recording source
changes as follows;
LDP VCR2 SOURCE
Start recording on the VCR 1.
Start play on the LDP(VCR 2).
– The audio and video signals from LDP(VCR 2) will be
dubbed onto the tape in VCR 1 and you can enjoy
LDP(VCR 2) on TV monitor and from speakers.
Listening to other audio input during dubbing
Example)Listening to CD during dubbing from LDP to VCR 1
Select CD as the input being enjoyed.
Select LDP as recording source with the VCR 1 RECORD
button.
Start recording on the VCR 1.
Start play on the LDP.
Start play on the CDP.
– The audio and video signals from LDP will be dubbed
onto the tape in VCR 1 and you can listen to CD.
11