Output Power Supply - GasTech GTA-4100R Operator's Manual

To install the extender card, remove the GTA-4100R by unscrewing the 2 screws securing it to the rack chassis.
The card will then slide out on its guides. Insert the Extender card and then plug the GTA-4100R into the
Extender card.
3.2.3

Output Power Supply

Different devices connected to the GTA-4100R have different power supply requirements. There are three
supported settings: 24VDC, adjustable 1.4-14Vdc, and zero output. There are two jumpers on the GTA-4100R
PCB which selects between these three settings – one for the top channel (J4) and one for the bottom channel
(J2)
Place the jumper in the correct position for the sensor being interfacing with each GTA-4100R channel.
Jumper Position
Page 17
Description
24VDC out 500mA max from the card
© 2008 GasTech Australia Pty Ltd
Output supply
jumper for top
channel