Setting The Audio Setup - Sherwood V-903 Operating Instructions Manual

SETTING THE AUDIO SETUP

-- AUDIO PAGE --
AUDIO OUT
DOWNMIX
AUDIO DRC
MAIN PAGE
Item menu
Press the CURSOR ▲/▼ buttons to select the preferred item.
1
When selecting the AUDIO OUT
Notes :
• This unit can output either analog audio signal or digital audio signal(, not both analog and digital audio signals concurrently).
Therefore, you should set the AUDIO OUT to either ANALOG or coressponding digital out setting(SPDIF/STREAM or
SPDIF/PCM) according to system connections, etc.
• When the DIGITAL OUT of the unit is connected to the DIGITAL IN of an amplifier which does not contain the Dolby Digital or
DTS decoder(which processes the bitstream signal), you should set the AUDIO OUT to SPDIF/PCM to convert Dolby Digital or
DTS bitstream to linear PCM(2 channel) of 48 kHz/16 bit and to output it.
• If the AUDIO OUT is not set correctly, loud noise or no sound may be heard from the speakers, and it may be harmful to your
ears and damage the speakers.
-- AUDIO PAGE --
AUDIO OUT
DOWNMIX
AUDIO DRC
When selecting the DOWNMIX
• Depending on whether the AUDIO OUTs(or the A/V SCART OUTPUT connector) are connected to a stereo
amplifier/receiver/TV or a A/V amplifier/receiver with built-in surround decoder, you should set the DOWNMIX correctly.
Notes :
• This setting is valid when the AUDIO OUT is set to ANALOG.
• The DOWNMIX setting affect only the output signal from the AUDIO OUT jacks(or the A/V SCART OUTPUT connector) when
playing back a DVD Video disc, etc. recorded in multi-channel signal format.
-- AUDIO PAGE --
AUDIO OUT
DOWNMIX
AUDIO DRC
• AUDIO OUT : When outputting either analog audio signal or a preferred
digital audio signal format.
• DOWNMIX : When outputting a preferred analog audio signal format.
ANALOG
• AUDIO DRC(Dynamic Range Compression) : When turning on or off the
SPDIF/STREAM
dynamic range compression that makes faint sound easier to hear at low volume
SPDIF/PCM
levels.
Setting menu
RC
• ANALOG : When outputting analog audio signal.
• SPDIF/STREAM : When outputting the digital audio signal as it was recorded.
• SPDIF/PCM : When converting DTS or Dolby Digital bitstream to linear
ANALOG
SPDIF/STREAM
SPDIF/PCM
• LT/RT : When you enjoy multi-channel surround sound by connecting the unit's
AUDIO OUTs to a A/V amplifier/receiver with built-in surround decoder.
• LO/RO : When you enjoy conventional 2-channel stereo sound by connecting
the unit's AUDIO OUTs to a stereo amplifier/receiver/TV.
LT/RT
LO/RO
• Then the setting menu of the selected item is displayed.
PCM(2 channel) of 48 kHz/16 bit and outputting it.
33