Pre Use Checks - Mantracourt BroadWeigh Original Instructions Manual

Pre Use Checks

Before rigging, check the shackles all work. Remove cover and insert 2 x AA batteries, observing polarity and
ensuring that there are no foreign objects the compartment. Wake them up by switching the handheld display
on- . All shackles on the same radio channel with the same group key will wake and their LEDs should start to
flash.
Cycle through the shackles on the display by pressing the select button- and check that the data tag shown
on the handheld matches the one on the shackle with its LED constantly on.
Alternatively, you can use the LOG100 software once the project has been configured (see below) to wake/sleep
the shackles and confirm that they are transmitting as expected.
It is a good idea to note down all the shackles' data tags and IDs and where they are located within the rig plot.
This is crucial for identifying which loads are being measured and where. The ID will be needed to soft pair.
BroadWeigh Handheld Display
7
Mantracourt Electronics Limited BroadWeigh Original Instructions