Installing the Detector Module
Installing the Detector Module
STEP 1
STEP 2
STEP 3
After installing the Detector module, check the LED statuses to make sure the
spectrometer is ready for use. Refer to
temperature stabilization if the detector is T.E.cooled (InAS, InGaAs).
30
Select the appropriate detector for your needs. The detector type is clearly
indicated on the Detector module.
Label type
Figure 7- 2. Label location on Detector module
The Detector module fits tightly into the housing of the Detector module,
gently push the Detector module into place.
Set all 3 captive screws of the Detector module into place. Do not overthighten.
Section 7 Module Replacement
Table 6-
1. A delay may be required for
AA003700-01 rev. G. 2.0