Regular Cleaning; Generalities; Procedure To Follow For Cleaning The Appliance - iMettos HM-12 Instruction Manual

4. If the meat suitably cut beforehand there should be no
problems with the screw feeder,however,if there are problems
tighten the lock nut until the meat is cut to desired size.
5. So both the disk and blade last longer and to maintain their sharpness in time:
- When all the meat has been minced turn off the appliance;
- Blade and disk must always be coupled.
6. Do not tighten the lock nut excessively;
7. Press the stop button when you have finished using the appliance, then strip the appliance and
thoroughly clean both the opening and all other components.

6.1 GENERALITIES


The appliance clean must be cleaned at least once a day or if necessary more than once.

Scrupulously clean all the various components of the HM-12/HM-22/HM-22A /HM-22B
whether they come in direct contact with the food product or not.

Never clean the HM-12/HM-22/HM-22A/HM-22B with a pressurized water-jet, industrial
cleaners, and brushes or any other type of cleaning utensil that could damage the surface of the
appliance.

Before cleaning you must remove the electricity supply plug isolating the appliance from
the main power circuit.
6.2 PROCEDURE TO FOLLOW FOR CLEANING THE APPLIANCE(see fig 6)
- remove the pestle and food tray;
- unscrew the lock nut and remove the disk:, blade screw feeder, unscrew in the direction indicated by
the arrow.
- unscrew the knob and remove the mincer, always in the direction indicated by the arrow.
Now all the components can be washed( see fig 7 )using warm water ( 50 ℃) and a neutral detergent.
To clean the main structure use a damp cloth remember to frequently rinse
The grater roller mounted on the HM-12/HM-22/HM-22A/HM-22B should be brushed cleaned. Carefully
clean the punched holes. Make sure all the components are completely dry before remounting them.
N.B. to remount the HM-12/HM-22/HM-22A /HM-22B follows the above diagrams:
1) Mount the mincer block and block it in position using the knob; the pin on the knob must be inserted
into the opening;
2) Insert the screw feeders into the mincer block make sure it is positioned correctly;
3) Mount the blade onto the square pin on the screw feeder and then mount the disk maintaining the
original coupling configuration;
4) Once all the components have been mounted secure by screwing the lock nut in place.
FIG 6-Removing components

6 REGULAR CLEANING

8