Scan The Patient Id - NeurOptics NPi-200 Instructions For Use Manual

Scan the Patient ID

Open a new SmartGuard® (Ex. 6).
Gently squeeze the SmartGuard side tabs to position onto the NPi-200.
There will be an audible click when the SmartGuard is properly
positioned (Ex. 7).
For the first patient use, in order to automatically write the patient ID into
the SmartGuard memory, scan the patient's ID bracelet with the Barcode Scanner.
Select either Barcode Scanner or Manual ID to indicate the patient ID entry method
to be used (Ex. 8).
Pairing the NPi-200 to the NeurOptics Antimicrobial Barcode Scanner
Connect the NeurOptics Antimicrobial Barcode Scanner and Charging Cradle to
the power supply and plug into a power outlet (Ex. 9). Turn on the Barcode Scanner
until an audible beep is heard and a blue light on the device flashes. Position
the Barcode Scanner next to the NPi-200.
On the NPi-200, select Barcode Scanner. The NPi-200 will
display "Connecting..." on the touchscreen (Ex. 10). Once
successfully paired, the touchscreen will prompt when the
device is ready to scan the patient ID barcode (Ex. 11).
The patient ID will now appear on the NPi-200 touchscreen. Confirm the
patient information is correct and select Accept (Ex. 12).
The NPi-200 will display the patient ID number and read "Ready to scan" (Ex. 13).
Manual Entry of the Patient ID
Press Manual Entry. Using the touchscreen, press the Patient ID.
Select Shift to toggle from alpha to numeric as required. When
the patient ID number has been manually entered, check for
accuracy and press Enter (Ex. 14 & 15).
NeurOptics® NPi®-200 Pupillometer System—Instructions for Use © 2018 NeurOptics, Inc.
Ex. 6
Ex. 10
Ex. 14
Ex. 7
Ex. 8
Ex. 9
Ex. 11
Ex. 12
Ex. 13
Ex. 15
4