Radio Wide Scan - E.F. Johnson Company 51 Series Preliminary Operation Manual

GENERAL OPERATION
Standard Scanning
Standard scanning monitors only channels that are the same type as
that currently selected. Therefore, if a conventional channel is selected,
only conventional channels are scanned, and if a SMARTNET channel is
selected, only SMARTNET channels are scanned. Standard scanning is
turned on and off by the Scan option switch as follows. If this switch is
not programmed, standard scanning is not available.
•
To turn standard scanning on, press the Scan option switch. Scanning is
enabled when the " Scan " icon is indicated in the upper right corner of
the front panel display and "SCAN ON" is briefly displayed.
•
To turn scanning off, press the Scan option switch again. The " Scan "
icon is then no longer indicated and "SCAN OFF" is briefly displayed.
•
If the zone or channel is changed while scanning is selected, scanning
continues on the same or a different scan list (see scan list information
which follows).
Radio Wide Scanning
Radio wide scanning monitors the channels in the preprogrammed
radio wide scan list (see page 25). This list may contain up to 16 channels
of any type (conventional or SMARTNET/SmartZone) assigned to any
zone. Radio wide scanning is turned on and off by the Radio Wide Scan
option switch as follows. If this switch is not programmed, radio wide
scanning is not available.
•
To turn radio wide scanning on, press the Radio Wide Scan option
switch. Scanning is enabled when " Scan " is indicated in the upper
right corner of the front panel display and "SCAN ON" is briefly
displayed.
•
To turn radio wide scanning off, press the Radio Wide Scan option
switch again. The " Scan " icon is then no longer indicated and "SCAN
OFF" is briefly displayed.
24