Selecting The Transmission Speed (Rs-232C); Fan Mode Setting; Checking The Lamp Life Status; System Lock Function - Sharp Notevision PG-F261X Operation Manual

Adjusting the Projector Function ("PRJ - ADJ" Menu) (Continued)
7 Selecting the Transmission
7 7 7 7
Speed (RS-232C)
Make sure that both the projector and computer
are set for the same baud rate.
Selectable
items
9600bps Transmission speed is slow.
115200bps Transmission speed is rapid.

8 Fan Mode Setting

8 8
8 8
This function changes the fan rotation speed.
Selectable
items
Normal Suitable for normal environments.
High Select this when using the projector at
altitudes of approximately 1,500
meters (4,900 feet) or more.
When "Fan Mode" is set to "High", the fan rotation
speeds up, and the fan noise becomes louder.
0 Checking the Lamp Life
0 0 0 0
Status
You can confirm the cumulative lamp usage time
and the remaining lamp life (percentage).
Lamp usage condition
"Life"
Operated exclusively
with Lamp Setting set to
"Eco +Quiet"
Operated exclusively
with Lamp Setting set to
"Bright"
Note
• It is recommended that the lamp be changed
when the remaining lamp life becomes 5%.
• The lamp life may vary depending on the us-
age condition.
44
Description
P
R
Description
Remaining lamp life
100% 5%
Approx. Approx.
3,000 150 hours
hours
Approx. Approx.
2,000 100 hours
hours
Menu operation n Page

9 System Lock Function

9 9 9 9
This function prevents unauthorized use of the
projector. Once this function is activated, users
must enter the correct keycode each time the
projector is turned on. We suggest you record
the keycode in a safe place where only au-
thorized users have access.
Info
• If you lose or forget your keycode, contact
your nearest Sharp Authorized Projector
Dealer or Service Center (see page 64). Even
if the product warranty is valid, the keycode
reset will incur a charge.
a Setting/Changing the keycode
1
Select "System Lock", then press
ENTER or Q.
2
Select "Next", then press ENTER.
• The screen for entering the keycode
appears.
3
Press the 4 buttons on the remote
control or on the projector to en-
ter the preset keycode in "Old
Code".
• When setting the keycode for the first
time, press R on the projector for four
times.
PRJ - ADJ
Setting the System Lock
Old Code
New Code
Reconfirm
Note
• If you input a wrong keycode, the cursor
returns to the first point of the "Old Code".
• The preset keycode is 4 R buttons on
the projector. When you press the R but-
ton four times, the keycord input screen
disappears.
37
– – – –
– – – –
– – – –