Assembly - Craftsman 151.30381 Operator's Manual

UNPACKING
This product requires assembly.
■ Carefully remove the product and any accessories
from the box. Make sure that all items listed in the
packing list are included.
WARNING!
Do not use this product if any
parts on the Packing List are already assembled to
your product when you unpack it. Parts on this list are
not assembled to the product by the manufacturer and
require customer installation. Use of a product that
may have been improperly assembled could result in
serious personal injury.
■ Inspect the product carefully to make sure no
breakage or damage occurred during shipping.
■ Do not discard the packing material until you have
carefully inspected and satisfactorily operated the
product.
■ If any parts are damaged or missing, do not operate
the blower. Return it for replacement to the retailer from
which it was purchased.
PACKING LIST
Blower / Vaccum
Blower Tube
Vacuum tubes
Concentrator nozzle
Collection Bag
Roller wheels
Operator's Manual
WARNING!
If any parts are damaged or
missing do not operate this product until the parts are
replaced. Use of this product with damaged or missing
parts could result in serious personal injury.
WARNING!
Do not attempt to modify this
product or create accessories not recommended
for use with this product. Any such alteration or
modification is misuse and could result in a hazardous
condition leading to possible serious personal injury.
WARNING!
Do not connect to power supply
until assembly is complete. Failure to comply could
result in accidental starting and possible serious
personal injury.

ASSEMBLY

ASSEMBLING THE BLOWER TUBE
See Figure 2.
■ Slide blower tube forward until the tab on the blower
housing clicks into the slots on the tube.
■ Insert the concentrator nozzle onto the blower tube
to lock. (Concentrator nozzle is used to increase air
flow in tight areas: flower beds, under decks, etc.).
INSTALLING VACUUM TUBE AND COLLECTION
BAG WITH SHOULDER STRAP
See Figure 3-9.
■ Assemble the vacuum tube sections by aligning and
sliding upper tube into the lower vacuum tube until the
different size tabs have "set".
■ Open vacuum gate. (Fig. 3)
■ Unscrew roller wheels, insert the wheel shaft into the
aperture under the vacuum tube and screw down the
wheels. (Fig. 4)
■ With gate open, align tabs on vacuum tube with
opening inside gate. (Fig. 5)
■ With assembled vacuum tube properly aligned,
insert into aligned gate opening and using the latching
gate lock, lock vacuum tube into place. Make certain
the vacuum tube aligning tab is firmly "seated" before
locking the latch. (Fig. 6)
■ Add collection bag by simply aligning the plastic
connector sleeve on the bag to the blower exhaust.
(Fig. 7)
■ While standing in the operating position adjust the
length to fit the operator's size. pull the tab to lengthen,
pull the strap to shorten. ( Fig. 8-9)
10 ― English