Connecting The Projector; Connecting The Power Cord; Connecting The Projector To A Computer - Sharp XG - NV6XU Operation Manual

2. Connecting the Projector

Connecting the Power Cord

Plug the supplied power cord into the AC socket on the back of the projector.

Connecting the Projector to a Computer

You can connect your projector to a computer for projection of full color computer images.
E-11
Power cord
QACCU5013CEZZ
Computer cable
QCNW-5304CEZZ
Computer audio cable
QCNW-4870CEZZ
CAUTION
• Before connecting, be sure to turn both the projector and the
computer off. After making all connections, turn the projector
on first. The computer should always be turned on last.
• Please read the computer's operation manual carefully.
• Refer to pages 55 and 56 "Input Signals (Recommended Timing)" for a
list of computer signals compatible with the projector. Use with computer
signals other than those listed may cause some of the functions not to
work.
Connecting an IBM-PC or a Macintosh computer
(Slide the 15 pin/BNC switch on the rear terminals to the 15
pin position.)
Plug one end of the supplied computer cable into the INPUT
1 or 2 port on the projector and the other end into the Monitor
output port on the computer, and secure the plugs by
tightening the thumb screws.
When connecting this projector to a computer, select
"Computer/RGB" for "Signal Type" on the GUI menu. (See
page 40.)
• A Macintosh adaptor may be required for use with some Macintosh
computers. Contact your nearest Authorized Sharp Industrial LCD
Products Dealer or Service Center.