Table of Contents
Advertisement
2.
With assistance, place the Bench Top Planer in the desired location on the work-
bench.
3.
Using the mounting hole located at each corner of the Base (part #111) as a
template, mark the spots where four 1/4" diameter holes will be drilled com-
pletely through the top of the workbench.
4.
Set the Bench Top Planer aside temporarily, and drill the four pre-marked 1/4"
holes through the workbench.
5.
Place the Bench Top Planer back on top of the workbench, and align its' four
mounting holes with the four pre-drilled holes in the workbench.
6.
Use four 1/4" diameter Hex Bolts of appropriate length, four Lockwashers, and
four Nuts (all not included) to firmly secure the Bench Top Planer to the work-
bench.
To Assemble The Stand For Use:
1.
NOTE: All hardware required to assemble the Stand ARE included as
accessory items with the Bench Top Planer.
2.
To assemble the Stand, use six Carriage Bolts (part #136), six Washers
(part #138), and six Nuts (part #139) to connect one Upper Side Brace
(part #131) to the upper portion of two Legs (part #133). Repeat this Step for
the remaining one Upper Side Brace and two Legs. (See Figure B.)
UPPER SIDE BRACE (#131)
LEG (#133)
LOWER SIDE BRACE
SIDE VIEW
SKU 04223
CARRIAGE BOLT
WASHER
(#138)
(#139)
(#134)
FIGURE B
UPPER FRONT/BACK BRACE (#132)
(#136)
NUT
LOWER FRONT/BACK
FRONT/BACK VIEW
PAGE 7
LEG (#133)
BRACE
(#135)
Advertisement
Table of Contents
