Table of Contents
Advertisement
SPECIFIC PRODUCT WARNINGS AND PRECAUTIONS
1.
MAINTAIN A SAFE WORKING ENVIRONMENT. Keep the work area well lit.
Make sure there is adequate surrounding workspace. Always keep the work
area free of obstructions, sawdust, grease, oil, trash, and other debris. Do not
use the Bench Top Planer in areas near flammable chemicals, dusts, and vapors.
Do not use the Bench Top Planer in a damp or wet location.
2.
DO NOT ABUSE THE POWER CORD. Do not use the Power Cord (part #22A*)
to pull its Plug from an electrical power outlet. Keep the Power Cord away from
heat, oil, sharp edges, and moving parts. Route the Power Cord safely. Do not
route the Power Cord where it can be walked on or tripped over. Replace a
damaged Power Cord immediately.
3.
THE BENCH TOP PLANER IS FACTORY PRE-WIRED FOR 120 VOLT AC
USAGE. The electrical Power Cord (part #22A*) for this product is equipped
with a grounded, 120 Volt AC, Plug. Never modify the Plug in any way. To com-
ply with the National Electric Code, and to provide additional protection from the
risk of electrical shock, this product should only be connected to a 120 Volt elec-
trical outlet that is protected by a Ground Fault Circuit Interrupter (GFCI).
4.
IF AN EXTENSION CORD (not included) IS USED, MAKE SURE TO USE
ONLY UL APPROVED CORDS HAVING THE CORRECT GAUGE AND
LENGTH . (See Figure A.)
REQUIRED MINIMUM EXTENSION CORD GAUGE – 120 VOLT
NAMEPLATE
AMPERES
(At Full Load)
8.1 - 12
FIGURE A
5.
REDUCE THE RISK OF ACCIDENTAL STARTING. Make sure the Power
Switch (part #21A*) is in the "OFF" position before plugging the Power Cord
(part #22A*) into a grounded, 120 Volt, electrical outlet.
(See Assy. Diagram.)
6.
PRIOR TO STARTING THE BENCH TOP PLANER, MAKE SURE ALL AD-
JUSTING KEYS AND WRENCHES ARE REMOVED FROM THE TOOL.
SKU 04223
EXTENSION CORD LENGTH
0 - 25
25 - 50
Feet
Feet
14
14
50 -100
Feet
12
PAGE 4
100 – 150
150– 200
Feet
Feet
-
-
Advertisement
Table of Contents
