Table of Contents
Advertisement
Operating Procedures
1.
Fill the cold water tank with clean cold water only.
Anything other than clean cold water used in the water tank will void the manufacturer's
warranty.
2.
Connect the Detergent Bottle to the detergent connection point on the machine.
3.
Fill the detergent bottle with Matrix approved detergent.
Unapproved detergent may be harmful or dangerous to the machine or the operator using the
machine. This may cause irreparable damage to seals and will void the manufacturer's
warranty. Any detergent used must be non-caustic and safe to use with steam. Please contact
the manufacturer of the detergent if there is any uncertainty.
4.
Connect the Vacuum Hose to the front of the machine ensuring it locks into position. To release the
vacuum hose from the socket slide the red button upwards at the same time as pulling the hose out.
If the Hose becomes damaged the complete hose must be replaced. Do not attempt this task
yourself, contact a Matrix approved supplier for replacement.
5.
Connect the Steam Hose to the front of the machine ensuring it is pushed in all the way and the pin
on the flap locks into the hole on the hose.
Grease "O" rings on steam pin before connecting.
To release the steam hose, lift the flap and pull.
6.
Plug the power cable into a 110 Volt supply.
Inspect the electric cable before every use. If the cable becomes damaged at any time the
complete cable must be replaced by a Matrix approved distributor.
Never touch the power cable or plug with wet hands
Always unplug the machine when
7.
Switch the On/Off switch to the ON position. The Heater On light LED will illuminate.
8.
Allow approximately 25 minutes for the boiler to heat the water
9.
When the Steam Ready LED illuminates the machine is ready to be used.
10.
The handle controls are now active.
The red trigger on the hose handle will release steam when pressed.
•
•
The red button on the side of the handle will lock the steam trigger in the off position.
Whenever the machine is not in use this must be locked in the off position
Pressing the left hand switch on top of the handle will activate the vacuum.
•
•
Pressing the right hand momentary switch located on the top of the handle will activate
the detergent pump. Hold the switch as long as you need to dispense the detergent.
Releasing the switch will stop the detergent supply.
11.
The steam output can be adjusted by the steam control knob
12.
Choose and fit the required accessory to the hose handle. Lock the accessory in place by turning
the accessory locking clip. For more information on various cleaning tasks and tools to use please
visit our website www.matrixcleaningsystems.co.uk.
When changing accessories during use please note these will be hot!!
-
The machine is not in use
Cleaning the machine
-
-
Any maintenance work is being carried out
5
Advertisement
Table of Contents
