Operating Procedures; Setting Up The Machine - Matrix SDV4 User Manual

Operating Procedures

1. Fill the cold water tank with clean cold water only.
Anything other than clean cold water used in the water tank will void the
manufacturer's warranty.
2. Fill the detergent tank with Matrix approved detergent.
Unapproved detergent may be harmful or dangerous to the machine or the operator
using the machine. This may cause irreparable damage to seals and will void the
manufacturer's warranty. Any detergent used must be non-caustic and safe to use
with steam. Please contact the manufacturer of the detergent if there is any
uncertainty.
3. Connect the Vacuum Hose to the front of the machine ensuring it locks into position. To
release the vacuum hose from the socket slide the red button upwards at the same time as
pulling the hose out.
If the Hose becomes damaged the complete hose must be replaced. Do not attempt
this task yourself, contact a Matrix approved supplier for replacement.
4. Connect the Steam Hose to the front of the machine ensuring it is pushed in all the way and
the pin on the flap locks into the hole on the hose.
Grease "O" rings on steam pin before connecting.
To release the steam hose, lift the flap and pull.
5. Plug the power cable into a 240 Volt supply.
Inspect the electric cable before every use. If the cable becomes damaged at any time
the complete cable must be replaced by a Matrix approved distributor.
Never touch the power cable or plug with wet hands
Always unplug the machine when
6. Switch the On/Off switch to the ON position. The Heater On light LED will illuminate.
7. Allow approximately 5 minutes for the boiler to heat the water
8. When the Steam Ready LED illuminates the machine is ready to be used.
9. The handle controls are now active.
• The red trigger on the hose handle will release steam when pressed.
• The red button on the side of the handle will lock the steam trigger in the off position.
Whenever the machine is not in use this must be locked in the off position
• Pressing the left hand switch on top of the handle will activate the vacuum.
• Pressing the right hand momentary switch located on the top of the handle will
activate the detergent pump. Hold the switch as long as you need to dispense the
detergent. Releasing the switch will stop the detergent supply.
10. The steam output can be adjusted by the steam control knob
11. Choose and fit the required accessory to the hose handle. Lock the accessory in place by
turning the accessory locking clip. For more information on various cleaning tasks and tools
to use please visit our website www.matrixcleaningsystems.co.uk.
When changing accessories during use please note these will be hot!!
- The machine is not in use
Cleaning the machine
-
- Any maintenance work is being carried out
5