Table of Contents
Advertisement
M23500
c. Power switching circuit
As the signal from the oscillator is amplified through Q7
to Q6 to change current to the transformer T2. it causes
voltage to appear on the base of Q5 (one of components
is cut by D1), so that the transistor Q5 begins to per-
form switching operation in synchronization with the
oscillation frequency. As Q2 is switched, current is
supplied to the emitter side of the transistor Q5, which
produces smoothed voltage through the capacitor C1
and the coil L2. The circuit composed of D4 and VR1 is
the reference voltage for the +5 or + 12V supply, which
is used to control the emitter current flowing to the
transistor Q9. The current supplied from Q9 is used to
create Tr3 inactive by the delayed C1 and C2 voltages
which supplied from Tr1-R2-VR1-D3. It goes high with
deactivation of Tr3.
3. Alarm circuit
(Alarm generation circuit)
When power turns off, the voltage accumulated in C1
and C2 are supplied to the base of Tr2 via Tr1 ... and
D3, so that Tr2 is kept active and Tr3 inactive for some-
times after power off.
Timing chart
SW
+ 5V
PFD
-89 -
Advertisement
Table of Contents
