Advertisement
Zone controllers: Require more than one thermocouple connection. It is
important to identify the thermocouples as Top, Middle or Bottom before
installing the thermocouples into the kiln.
Optional Vent Fan
If your controller is equipped for Vent fan operation, the Vent fan for your kiln
should be plugged into the outlet on the bottom of the controller. This outlet is for
a Vent Fan only. The supply voltage to the Vent Fan is 120volt AC. The
controller is equipped with a 120V power cord for powering the vent fan option.
This cord is required only for use with the optional Kiln vent control. If you are not
using the Vent Fan option, the optional power cord does not need to be plugged
in for normal kiln control operation.
10/31/2018
Advertisement
