Advertisement
Once the controller is mounted to the wall, plug the controller power cord into the
wall receptacle and the kiln cord into the controller receptacle.
Direct wire controllers: It will be necessary to remove the front cover of the
controller for access to the internal terminal strips for wire connections.
Connection labels will be found at the terminal strip or relay connections.
To install the optional Hand-Held controller; simply connect the 14-pin plug from
the Hand-Held controller to the mating jack on the left side of the wall box.
Fasten the restraining clips on the connector to prevent the controller from being
accidentally disconnected.
The top of the Hand-Held controller has an eye bolt for hanging the controller in
a convenient location. It is recommended that the controller be mounted at eye
level.
Do not mount the controller directly above the kiln or other heat source.
•
Cables should not be able to come in contact with the hot kiln.
•
Never lay the controller on top of the kiln.
•
Hand-Held Controller Option
10/31/2018
Advertisement
