Canon Multi-PDL Printer Kit-E1 Service Manual page 35

Chapter 3
4) Push the locking lever [1] to detach the boot ROM [2].
5) Fit the included boot ROM [1] in place.
6) Attach the face cover using 4 screws.
7) Tighten the 2 screws loosened in step 2).
8) Connect the host machine's power cable (to the wall outlet).
9) Turn on the main power swish.
3. Checking the Installation
Make the following selections, and check the state of the following bits: COPIER >
ACC-STS > PDL-FNC1.
111x xxxx xxxx xxxx (0: OFF; 1: ON)
In the case of the PDL-FNC1, bits 31 through bits 16 are indicated.
Be sure that the following bits are '1': 31, 30, 29.
3-6
F-3-6
F-3-7