Arming Using The Remote Control - Sector Alarm PhoneWatch TC User Manual

Arming using the remote control

Keep in mind that the remote control arms the system instantly. You should therefore be careful
not to arm the alarm until you are outside of the protected zone.
Full Arm mode (arms the entire alarm system)
Close all of the exterior doors and windows before arming the system.
Press the button Full Arm mode.
The button confirmation light will light up for a few seconds to confirm arming. In the case of
a system error, you will need to rectify the error and then try to arm the system again.
Part Arm mode (arms part of the alarm system*)
Close all of the exterior doors and windows before arming the system.
Press the button Part Arm mode.
The button confirmation light will light up for a few seconds to confirm arming. In the case of
a system error, you will need to rectify the error and then try to arm the system again.
Check status
To check the status of the system you press the status button with question mark and
the button of the current panel status will light for a few seconds.
* Part Arm mode is programmed according to your needs. Your PhoneWatch Engineer can
program the alarm according to your preferences.
Full Arm mode
Disarm button
HOW TO USE THE ALARM SYSTEM
Panic Alarm function
Part Arm mode
Status button
9