How To Use The Alarm System; Arming Using The Keypad - Sector Alarm PhoneWatch TC User Manual

How to use the alarm system

The alarm system is easy and convenient to operate using the
keypad, remote control or keytag.

Arming using the keypad

Full Arm mode (arms the entire alarm system)
Close all of the exterior doors and windows before arming the system.
Press the button Full Arm mode and either enter your personal code or use
your keytag.
The signal light 1 will light up and flash to confirm the command before switching off
again.
A warning alert will sound for a moment as you leave. In the case of a system error,
a warning tone will be emitted. You should rectify the system error and then try to
arm the system again.
Part Arm mode (arms part of the alarm system*)
Close all of the exterior doors and windows before arming the system.
Press the button Part Arm mode and either enter your personal code or use
your keytag.
The signal light 1 flash until the alarm is armed.
No warning alert will sound as you leave (If set to Part Arm silent). In the case of a
system error, a warning tone will be emitted. You should rectify the system error and
then try to arm the system again.
* Part Arm mode is programmed according to your needs. Your PhoneWatch Engineer can
program the alarm according to your preferences.
8 SECTOR ALARM – DOMONIAL USER INSTRUCTIONS HOW TO USE THE ALARM SYSTEM 4