Rheem 441 Series Owner's Manual And Installation Instructions page 36

Gas domestic indoor water heater
Hide thumbs Also See for 441 Series:
Table of Contents

Advertisement

LIGHTING INSTRUCTIONS
Using the gas control light the water heater as follows:
1.
Stop,
read the safety information
Turn the gas control knob fully clockwise to the "" (off) position.
2.
3.
Remove the front cover below the gas control.
4.
Wait five (5) minutes so any build-up of unburnt gas can escape. If you then
smell gas, stop and follow "C" in the safety information. If you do not smell
gas, proceed to step 5.
Turn the knob to the "" (pilot) position.
5.
6.
Depress the knob fully (until star disappears below housing) and after
30 seconds, whilst keeping the knob depressed, repeatedly press the igniter
button (for up to 40 seconds) until the pilot flame ignites.
Warning: Keep your face clear of the combustion chamber opening
while pressing the igniter.
Note: It is not possible to depress the knob fully if the gas control has
activated its safety shut-off feature. In this case, wait 60 seconds for the gas
control to reset.
7.
Keep the knob depressed for 20 seconds after the pilot flame lights.
8.
Release the knob and check the pilot is still alight. The pilot can be checked
by looking through the large opening below the gas control.
9.
If the pilot has failed to light or has not remained alight, turn the gas control
knob to the "" (off) position. Wait five (5) minutes for any unburnt gas to
escape and then begin again at step 5.
Warning: Failure to wait five (5) minutes may result in a fire or explosion.
10. When the pilot flame remains alight with the gas control knob released, turn
the knob anticlockwise to the setting of '6'. This will give a water temperature
of about 60°C.
"Temperature Adjustment"
11. Refer to
adjustment is required.
12. Replace securely the front cover.
The main burner will now automatically ignite when heating is required and
extinguish when the water has been heated to the set temperature. If the main
burner does not light at the selected setting, the water may already be at the
selected temperature.
Note: Never press the igniter button while the top knob is in a numbered position.
318457 Rev D Issued: 15/11/18
LIGHTING THE WATER HEATER
on page 35.
on page 5, if further temperature
36

Advertisement

Table of Contents
loading

This manual is also suitable for:

441 135no441 170no

Table of Contents