Adjusting The Backlight - Sharp LD-23SH1U Operation Manual

Notes:
- When you turn on the TV, the initial display mode
will be the mode being used when the TV was
last turned off. (The factory setting is TV.)
- The CH buttons or channel buttons (0-9 and
100) also automatically switch to TV mode,
except for the following cases when in PC mode.
- When watching TV in the PIP/SPLIT window.
(See page E43.)
- When listening to the TV. (See page E44.)
In these cases, press the TV button to switch the
display mode to TV.
- Pressing the INPUT button on the TV also
changes the display mode. Each time you press
the button, the input changes in the following
order:
Number (TV) → AV1 → AV2 → PC (analog) →
PC (digital) → Number (TV)...
- In PC mode, when there is no input signal,
"NO SIGNAL" is displayed.
Common operations

Adjusting the backlight

The brightness of the backlight can be set
individually for PC mode and TV/AV mode. Start by
switching to the display mode for which you want
to adjust the backlight.
1. Press the BRIGHT button.
2. Press the
Increase
Decrease
The screen for adjusting the brightness will
automatically disappear after several seconds.
Note:
- You can also adjust the brightness using the
control buttons on the TV.
1. Press the VOL/BRIGHT buttons.
2. Press the MENU button to select "BRIGHT".
3. Press the VOL/BRIGHT buttons to adjust the
brightness.
Increase
Decrease
The screen for adjusting the brightness will
automatically disappear after about 15
seconds.
E28
POWER
PC TV AV1
FREEZE MULTI VIEW MODE
SLEEP
ENTER
BRIGHT
MODE
BRIGHT 31
buttons to adjust the brightness.
button
button
VOL/BRIGHT > button
VOL/BRIGHT < button
Virtual
AV2
MENU
BRIGHT
< >
PC