Download Print this page

SaunaFit Panoramic-View Cedar Barrel Assembly Instructions Manual page 11

Advertisement

IMPORTANT: Operate the heater for an hour with the sauna door fully open to burn off any residual coating from
the manufacturing process
Congratulations! You have successfully assembled your Cedar Barrel Sauna.
The Head / Back Rests can be placed anywhere
they are needed.
The door handle usually goes in the centre of the
door (left) and the Towel Bar is made to go on
the inside of the door (below) but can be
installed lower or higher as desired. It usually
goes about half-way vertically. Use 1½"screws.
The heater goes beside the door on the side of the
front wall with the short bench.
Pictured is the Tylo Sport Sense heater. See the
manufacturer's installation guide for your heater.
The heater guard might look a little different
than the one pictured, depending on your
sauna and heater type. Fasten with screws
provided with the heater.
Wash the rocks thoroughly before placing them
into the heater or you'll have a muddy mess when
you put water on them.

Advertisement

loading

Related Products for SaunaFit Panoramic-View Cedar Barrel