Table of Contents
Advertisement
Quick Links
Cabin Sauna Assembly Instructions
Please read and understand the complete instructions prior to assembly and use of your
Indoor Western Red Cedar
Required:
•
2 People (recommended)
•
Rubber Mallet
•
6' Step Ladder
•
Cordless Drill & #2 Robertson Bit
•
Red Robertson screwdriver
•
Carpenter's Level
•
7/16" Wrench
•
Tape Measure
Advertisement
Table of Contents
Related Manuals for SaunaFit Indoor Western Red Cedar
Summary of Contents for SaunaFit Indoor Western Red Cedar
- Page 1 Indoor Western Red Cedar Cabin Sauna Assembly Instructions Please read and understand the complete instructions prior to assembly and use of your Required: • 2 People (recommended) • Rubber Mallet • 6’ Step Ladder • Cordless Drill & #2 Robertson Bit •...
- Page 2 Start by deciding where you would like your indoor cabin sauna to be placed. Locating it over a moisture-sensitive surface such as hardwood or engineered flooring is not recommended as there could be some spillage of water from time to time, and heat and humidity over time could have an adverse effect on certain flooring materials.
- Page 3 After the first layer of wall boards has been assembled, begin placing the short boards on the front side of the sauna to frame the door. Note, as always, rabbeted sides face inward. Fig 4.1 Fig. 4.2 Fig. 4.3 Fig. 4.4 Note: You can invert the pre-hung door assembly (prior to attaching the handles) to change the direction that the door opens.
- Page 4 6. Assemble the roof, starting with an end piece with trim, and continuing a board at a time across to the other side. Fig. 6.1 Fig. 6.2 Fig. 6.3 Tighten up the spacing between boards as you go. Use the included 2” wood screws every second board into the top boards of the front and back walls. Fig.
- Page 5 Fig. 6.5 Place the final roof board/trim assembly and secure with 2” screws Then apply the front and back trim. Fig. 6.7 Fig. 6.6 Fig. 6.8...
- Page 6 7. Attach the towel pegs where you want them. Fig. 7.1 Four #2 Robertson flathead wood screws Fig. 7.2 Beside the door is a good place for towel pegs. 8. Attach the Towel Rack on the inside of the door and the Door Handle on the outside of the door at preferred height. Fig.
- Page 7 10. Install the moulding on the corners of the sauna with supplied screws in 4 places per side (every fifth board or so). Avoid cracks. See Fig. 10.2 Important note on aligning wall corners: Before securing the corner moulding assemblies (Fig. 13.1), use a rubber mallet to align the corner joints and close up any visible cracks in the inside corners: With the nut on the top of the threaded rod snug, (not...
- Page 8 HOW TO TAKE A SAUNA 1. Pre-heat your sauna to the desired temperature. The preferred temperature for perspiration is between 80-95°C. Higher temperatures may actually inhibit perspiration. The amount of time needed to heat a sauna to the desired temperature should be 20-30 minutes.
Need help?
Do you have a question about the Indoor Western Red Cedar and is the answer not in the manual?
Questions and answers