PetPal CC360 Owner's Manual page 7

PARTS & FUNCTIONS
Intensity Selection Dial
The intensity selection dial allows you to choose between
15 different levels of stimulation for very precise control.
On the 'M' setting, you can choose between regular and
Battery Saving Mode* (see page 12).
Transmitter Antenna
Be sure to check that the antenna is securely fastened to
the transmitter before each use. Hand-tighten only: over-
tightening can cause damage to the antenna or the
antenna mount.
Magnet Indicator (Red Mark)
The Magnet Indicator marks the location of the magnet in
the Transmitter. The magnet is used to turn the Collar
Receiver ON/OFF and for ID reprogramming.
Transmitter LED Indicator Light
When any of the buttons on the transmitter is pushed,
the LED light will turn on to indicate that the transmitter is
being operated. When the battery is low, the LED light
will flash rapidly.
Remote Training Buttons
Pressing the "Cont." button sends a Continuous
Stimulation from the Collar Receiver to your dog.
Pressing the "Beep" button emits an audible beep from
the Collar Receiver.
*IMPORTANT NOTE:
In Battery Saving Mode, there may be a slight delay in the
Collar Receiver's response to the Transmitter. This feature
was added to prolong battery life (see page 12).
7