Schlage M400 Series Installation Instructions Manual page 6

5
Install mounting bracket into frame.
5a Attach mounting bracket temporarily
• Install two middle screws into slots and partially tighten.
5b Remove wiring cover.
5d Align magnet to armature.
• Close door.
• Press magnet to fully engage with armature.
• Mark bracket location.
Mark here
Press magnet to armature
6
Pull wires
Partially
tighten
Actual Size
Reinforced
Metal
Sheet
Metal
5c Slide magnet onto bracket.
5e Fully attach bracket.
• Remove magnet from bracket.
• Check bracket alignment with marks.
• Fully tighten two screws in slotted holes.
• Drill four (4) remaining holes.
• Fully tighten all screws.
Actual Size Sheet
Metal
E
I D
T S
O U
Check
alignment
Fully tighten
all screws
Drill four (4) holes
Reinforced
Metal
Use 10-24 tap
if reinforced metal