3. Do not place the appliance near cookers, radiators or in direct sunlight as this
will cause your appliance to work harder. If installed next to a source of heat
or freezer, maintain the following minimum side clearances:
4. Make sure that sufficient room is provided
around the appliance to ensure free air
Fit the Two plastic wall spacers
supplied with the appliance rotating
1/4 turn to the condenser at the back
of the appliance (See Diagram).
5. The fridge/freezer should be located on a
smooth surface. The two front feet
can be adjusted as required. To ensure
that your appliance is standing
upright adjust the two front feet by turning
clockwise or anti-clockwise, until
the product is in firm contact with the floor.
Correct adjustment of feet avoids
excessive vibration and noise.
6. Refer to cleaning and care section to prepare your appliance for use.
A special receptacle is supplied to store the mains plug during transit.
The receptacle is fixed at the back of the
cabinet, on the side of the compressor.
(See diagram) Gently remove the plug
from the receptacle. Never pull the
mains cord, you may damage the
appliance. In the case of transportation,
ensure you locate the plug in the receptacle
provided to avoid transit damage.
50 mm (2")
300 mm (12")
25 mm (1")
GETTING TO KNOW YOUR COMBI BEKO FRIDGE / FREEZER