Advertisement
Mounting:
Mount the 37038AS LED light using the brackets supplied and user supplied mounting screws.
CAUTION: Check the chosen mounting location to ensure that the vehicle's structure and material is adequate to support the
weight of your light.
Adjustment:
After the 37038AS light is securely installed, loosen the adjusting screws located on each end and tilt the light to the
desired angle. Then tighten the screws. Turn the LED light on and check the light from the front or rear of the vehicle,
through the window, to ensure that it is at the most desirable angle, and that the light is not impeded by any obstacles
and/or window tinting.
Operation:
ON/OFF FLASH SWITCH: The 3 position rocker switch used to control the LED flash brightness/ off states.
CENTER LEFT/ SWITCH: The rocker switch to control LED from right to left.
CENTER RIGHT/ SWITCH: The rocker switch to control LED from left to right.
Note: Both CENTER switches in UP position puts unit in CENTER operation.
ON/OFF PATTERN SELECT MODES:
DN= Turn the 2 position switch to off/Turn the 3 position switch to DOWN position.
UP= Turn the 2 position switch to on/Turn the 3 position switch to UP position.
X= Turn the 3 position switch to MIDDLE position.
The 3 position rocker switch in UP mode is in DIM state/ in DN mode is in BRIGHT state.
※
Touching the yellow wire to the black wire (ground) will change the flash patterns.
※
Switch Position
ON/OFF
CENTER
CENTER
FLASH
LEFT
RIGHT
X
DN
DN
DN
UP
DN
DN
UP
UP
UP
DN
DN
UP
DN
DN
UP
UP
UP
LAMP 1
LAMP 2
Operation
DN
OFF
DN
FLASH (BRIGHT)
DN
FLASH (DIM)
DN
RIGHT SWEEP(BRIGHT)
DN
RIGHT SWEEP(DIM)
UP
LEFT SWEEP(BRIGHT)
UP
LEFT SWEEP(DIM)
UP
CENTER (BRIGHT)
UP
CENTER (DIM)
LAMP 3
P1
P2
P3
P4
LAMP 4
LAMP 5
NOTE
OFF
P9 P13 P17 P21 P25 P29
P5
P6 P10 P14 P18 P22 P26 P30
P7 P11 P15 P19 P23 P27 P31
P8 P12 P16 P20 P24 P28 P32
LAMP 6
LAMP 7
LAMP 8
Page 2 of 6
Advertisement
