Changing Channels Analog-Tv; Changing Channels Digital-Tv - Sharp Aquos LC 32GD6U Operation Manual

Watching TV
Changing channels - Analog-TV
You can change channels in several ways.
NOTE
• While watching a broad cast, press A-ANALOG-B to view
the image received from the other tuner.
Method 1
Using CHr/s on the remote control unit or on the
display.
Method 2
1. Press FLASHBACK to switch to the previously tuned
channel.
2. Press FLASHBACK again to switch back to the
currently tuned channel.
NOTE
• FLASHBACK will not work if no channel has been
changed after TV is turned on.
Method 3
Using remote control buttons (0-9
up to 125 channels for VHF/UHF/CATV.
To select a 1 or 2-digit channel number
(e. g., Channel 5):
Press 5 s ENTER
ANALOG-A Air
5
NOTE
• When selecting a 1-digit channel number, it is not
necessary to press 0 before the number.
• When you enter 0-9 only, channel selection will be made
if there is no operation for a few seconds.
• • (DOT) can be used instead of ENTER.
To select a 3-digit channel number
(e. g., Channel 115):
Press 1 s 1 s 5
ANALOG-B Cable
1
NOTE
• When you enter 0-9 only, channel selection will be made
if there is no operation for a few seconds.
• If you push "0" by itself, nothing will happen.
22
and ENTER) to select
ANALOG-A Air
5
ANALOG-B Cable ANALOG-B Cable
11 115
Changing channels - Digital-TV
You can change channels in several ways.
As well as the methods outlined below, you can also select
programs using the Channel List. (See page 85.)
NOTE
• While watching a broad cast, press DIGITAL.
Digital - Air/Cable
Method 1
When you press CHr/sor FLASHBACK, repeat the
same steps for Analog-TV.
Method 2
Using remote control buttons (0-9,
ENTER) to select the channels including a decimal
point.
To select a 4-digit channel number
(e. g., Channel 22.1):
Press 2 s 2 s•(DOT) s1s
DIGITAL Air DIGITAL Air DIGITAL
2 22
NOTE
• Complete the above steps within a few seconds.
• When you enter 0-9 and •(DOT), channel selection will
be made if there is no operation for a few seconds.
• When entering a 2-part channel number, pushing •(DOT)
after the second part of the number has the same function
as ENTER.
Digital - Cable (One-part Number)
Method 1
When you press CHr/sor FLASHBACK, repeat the
same steps for Analog-TV.
Method 2
Using remote control buttons (0-9
the channels including a decimal point.
To select a 3-digit channel number
(e. g., Channel 310):
Press 3 s1s0s ENTER
DIGITAL Cable DIGITAL Cable
3 31
NOTE
• When you enter 0-9 only, channel selection will be made
if there is no operation for a few seconds.
• •(DOT) can be used instead of ENTER.
• Digital Cable Channels are shown by a number with a
maximum of 5 digits.
• (DOT) and
ENTER
Air DIGITAL Air DIGITAL Air
22. 22.1 22.1
and ENTER) to select
DIGITAL Cable DIGITAL Cable
310 310