Power Control; Power Control For Av Source; Power Control For Pc Source - Sharp Aquos LC 26GA5U Operation Manual

Basic adjustment settings

Power control

Power control setting allows you to save energy.

Power control for AV source

No signal off
When set to "Enable", the power will automatically shut
down if no signal inputs for 15 minutes.
1
Press MENU and the MENU screen displays.
2
Press c/d to select "Power Control".
3
Press a/b to select "No Signal Off", and
then press ENTER.
4
Press c/d to select "Enable", and then
press ENTER.
Enable
• Five minutes before the power shuts down,
remaining time displays every minute.
NOTE
• "Disable" is factory preset value.
• When a TV program finishes, this function may not operate.
No operation off
When set to "Enable", the power will automatically shut
down if there is no operation for 3 hours.
1
Repeat steps 1 and 2 in No signal off.
2
Press a/b to select "No Operation Off", and
then press ENTER.
3
Press c/d to select "Enable", and then
press ENTER.
• Five minutes before the power shuts down,
remaining time displays every minute.
NOTE
• "Disable" is factory preset value.
26
LC-26/32GA5U(E)-22-26
Disable
26

Power control for PC source

Power control setting allows you to save energy.
Power management
When set, the power will automatically shut down.
1
Repeat steps 1 and 2 in No signal off.
2
Press a/b to select "Power Management",
and then press ENTER.
Press a/b to select "Mode1" or "Mode2",
3
and then press ENTER.
Off
Mode1
Mode2
Selected item
• No power management
Off
• Factory preset value.
• If no signal inputs for 8 minutes, the power
shuts down.
• Even if you start using the PC and the signal
Mode1
inputs again, the TV stays off.
• The TV turns on again by pressing TV
POWER on the remote control unit. (See
page 14).
• If no signal inputs for 8 seconds, the TV
enters standby mode.
Mode2
• When you start using the PC and the signal
inputs again, the TV turns on.
NOTE
• When using a digital PC and setting "Mode2" in Power
management, the power may not turn back on
automatically even if the signal inputs again.
• If you turn off the power by disconnecting AC cord when
setting "Mode2" in power management, the TV may not
function properly after turning the power on again. In such
case, press TV POWER on the remote control unit.
04.9.15, 7:46 AM
Description