Advertisement
902-757 Corkscrew Aztec Climber
STEP #3:
Secure the Plastic Panel to the Ground Anchor by placing a bolt
and washer in a bolt cap and pushing through the aligned hole in
the Plastic Panel and Ground Anchor. Fasten by placing a washer
and nut in a second bolt cap and securing to the bolt from the
opposite side. Repeat this process for the other two holes.
STEP #4:
Repeat Steps 1, 2 and 3 with other Ground Anchor and Plastic
Panel.
STEP #5:
Attach the other side of the Aztec Plastic Panel to the Vertical
Connecting Post utilizing the same fastening technique as was
used in steps 1 and 2.
Note: The Dragon Figure must be at the top of the Panel
STEP #6:
Spot area for Horizontal Connecting Post. Area should resemble
picture below. Approximate height of the hole on lower tab on the
main post to the top of the safety surfacing is 47"
SportsPlay Equipment, Inc., 5642 Natural Bridge, St. Louis, MO 63120 (314) 389-4140
www.sportsplayinc.com
8
Page
Rev. 04/9/2010
Advertisement
