LG MULTI V Installation Manual page 92

Test Run
Static pressure compensation mode
This function secures the air flow rate of ODU, in case static pressure has been applied like using duct at fan
discharge of ODU.
n Static pressure compensation dip S/W setting method
High static pressure mode : Set DIP S/W
Static pressure compensation mode setting
Static pressure compensation mode is set
Note
How to set the unit to high ESP :
1) Standard ESP (External Static Pressure) : 4mmH
2) High ESP (External Static Pressure) : 8mmH
' The setting of dip S/W is needed. (Refer to above operating method)
92 Outdoor Unit
method
Set the DIP S/W ON
Power Reset
Warning : Please reset Main PCB before starting this function
O (78.4Pa)
2
Static pressure compensation mode cancellation
Static pressure compensation mode is cancelled
DIP Switch Settings
O (39.2Pa)
2
method
DIP switch OFF
Power Reset