Operation; Basic Setup - Linking Devices; Unlinking Devices; Linking Multiple Transmitters With Multiple Receivers - Wireless Solution W-DMX G3 User Manual

5. Operation

All W-DMX™ devices share the same user interface – these instructions apply to all products:
5.1. Basic setup – Linking devices
A basic setup is defined by the link between two devices. This means that, in order to send data
from a transmitter to a receiver, it's necessary to pair the devices:
Press the red function button, on the transmitter, for 1 second, until the LINK LED starts flashing.
NOTE: All available receivers, as long as they are turned on and compatible with the transmitter's
radio mode, will pair with this transmitter. The LINK LED of each receiver will flash for 5 seconds, and
stay static once linked up.
There is no limited number of receivers that can link up with a transmitter – there can be an infinite
number of receivers all paired with a single transmitter.

5.2. Unlinking devices

There are two ways to unlink devices – individual unlink, or group unlink:
Individual unlink:
Press and hold the red function button, on each receiver, for 5 seconds. The LINK LED should turn
off.
Group unlink:
Press and hold the red function button, on the transmitter, for 5 seconds. All paired and powered
receivers will unlink.

5.3. Linking multiple transmitters with multiple receivers

When multiple receivers need to be linked up with different transmitters, repeat the process in 5.1.,
but turn off all receivers you do not wish to pair up. For example:
- If you have 2 transmitters and 10 receivers, pair the first transmitter to 5 receivers, while the last
five are turned off.
- After that, turn the last five receivers, and pair them to the second transmitter.
NOTE: This will not affect any receiver that has already been paired up.
User Manual - English
red function button
9