Page 1
How to install the G5 Ethernet Module 1. Remove the rubber feet from the bottom of your BlackBox and the four screws attaching the lid to the main chassis. On the WhiteBox, please remove all six screws attaching the lid to the frame.
Page 2
4. Place these spacers in their rightful holders on the Add-On Board. These spacers do not need any screws, they are self-retaining spacers. Once these are attached, you may fit the ethernet module into the 10-pin, dual-row connector labelled as “BLUEBOX”. 5.
Page 3
6. Place the radio cards back into their original position. Make sure the pins mate precisely with their connectors on the Add-On board, and screw the cards into the spacers. 7. Close the lid and screw in the four screws on the BlackBox or the six screws on the WhiteBox.