Advertisement
Notice on the first switch to the left, from the start button, there is a red jumper from
the circuit breaker directly below it for power. You will install the pink control wire with the
doubled red wire onto the output of this switch. This short red wire will then be routed to
the second circuit breaker to the left of the start button and the pink wire will be routed
out to the ignition coil. With this setup you will then have an ignition hot only switch that
can be used for a variety of functions of your choice.
Six or Four (depending on which kit you have) terminated jumper wires are
provided to supply power from the circuit breakers to the toggle switches.
4
Advertisement
