Sharp DV-SR45U Operation Manual page 94

Symptom
Others
The DVD recorder does not operate
properly.
The disc tray does not open when you
press OPEN/CLOSE A button.
"Repairing" appears on the display.
Repairing
Error message
Disc Error
--- Please eject the disc. ---
Playback feature may not be
available on this Disc.
Region Error
--- Please eject the disc. ---
Playback is not authorized in your
region.
Parental Lock On
--- Please eject the disc. ---
The current selected parental level
Prohibits playback.
Recording Error
This program is not allowed
to be recorded.
Recording Error
This program is not
recordable in Video mode.
Recording Error
Can not record on this disc.
Recording Error
This program is not allowed to
be recorded on this disc.
Recording Error
This disc is protected and not
recordable.
Recording Error
Disc is full.
(No area for new recording)
94
Others
Troubleshooting (cont'd)
Remedy
• When static electricity, etc., causes the DVD recorder to
operate abnormally, unplug the DVD recorder and then plug it
in again.
• It may take a few seconds for the disc tray to open after you
have recorded or edited a disc.
• This is because the DVD recorder is adding disc data to the
disc.
• If there is a power failure or unplugging during recording,
finalizing, formatting or editing, a Repairing process will begin
automatically just after turning the unit on again.
It may take several minutes up to about four hours.
Cause
Unplayable disc is inserted
in the DVD recorder.
The disc is upside down.
Playback is not authorized
in the region of the DVD-Video
disc which you inserted in the
DVD recorder.
The current selected parental
level in the SETUP Menu
prohibits playback.
The recording function encountered
the copy prohibited program.
You are trying to record the copy-
once program onto the DVD-RW
disc in Video mode.
You are trying to record onto the
disc which is unrecordable, or the
disc status is unable to record.
The disc is dirty.
The disc is damaged.
You are trying to record the copy-
once program onto the DVD-RW
disc which is not compatible with
CPRM.
You are trying to record on to the
protected disc which is set in the
Disc Setting Menu.
You are trying to record onto
the disc which has no space
for recording.
Solution
Insert the standardized disc which
bear the marks on page 41.
Insert the disc with the labeled side
facing up.
Insert the DVD-Video disc with
region codes 1 or ALL.
Check the "Parental Lock" setting
(pages 90-91).
You cannot record copy prohibited
programs.
Set "DVD-RW Recording Format"
to "VR mode" (page 28).
Insert the recordable disc, and
ensure the disc status satisfies the
recording requirements
(pages 26-27).
Clean the disc with a cleaning cloth.
Replace the disc.
Insert the DVD-RW disc
(ver.1.1 compatible with CPRM).
Release the disc protect setting
in the Disc Setting menu (page 40).
Insert the recordable disc with
enough recording space.