Connection - Waeco ECL-75 Installation And Operating Manual

_ECL-75_102.book Seite 39 Donnerstag, 6. Mai 2010 4:43 16
ECL-75, ECL-102
7

Connection

Caution
Make sure that you run the on/off cable away from live power cables.
Warning
To prevent short circuits, always disconnect the negative terminal of the
vehicle battery before working on the vehicle electrical system.
If the vehicle has an additional battery, its negative terminal must also
be disconnected.
Warning
The cable cross section for the connection between the starter battery, power
relay and consumer battery must not be less than 16 mm² for the ECL-75 and
25 mm² for the ECL-102. Also check that the cable between the negative
terminal of the consumer battery and vehicle chassis is at least 16 mm² and
25 mm² respectively – you might need to replace the cable provided with a
thicker one. The minimum cable cross sections are listed in the following table.
The table shows the combinations possible of roof air conditioners, charging current
distributors and inverters and the necessary cable cross sections of the access leads:
Roof air
conditioner
Dometic CA1000
Dometic CA1000
Dometic CA2500
Dometic CA2500
Dometic B1600
Dometic B1600
Dometic B1600 Plus ECL-102
Dometic B1600 Plus ECL-102
Dometic B2200
Dometic B2200
Dometic HB2500
➤
Mount the ECL-75 / ECL-102 charging current distributor and the corresponding
relay in such a way that they remain fixed, dry and well-ventilated, ideally in direct
proximity to the inverter.
Charging current
Inverter
distributor
(item no.)
(item no.)
ECL-75 PerfectPower PP1000
(8100-12VS)
ECL-102 SinePower SP1500
(item no. MSK1500-012)
ECL-102 ECW-012VS
ECL-102 SinePower SP1500
(item no. MSK1500-012)
ECL-102 ECW-012VS
ECL-102 SinePower SP1500
(item no. MSK1500-012)
ECW-012VS
SinePower SP1500
(MSK1500-012)
ECL-102 ECW-012VS
ECL-102 SinePower SP1500
(item no. MSK1500-012)
ECL-102 SinePower SP1500
(item no. MSK1500-012)
Connection
Cable cross
section
16 mm minimum
2
25 mm minimum
2
25 mm minimum
2
25 mm minimum
2
25 mm minimum
2
25 mm minimum
2
25 mm minimum
2
25 mm minimum
2
25 mm minimum
2
25 mm minimum
2
25 mm minimum
2
39